Notions: Finishing your Simple Skirt

Well, phew! I have finally gotten around to finishing my instructions for this Skirt, & am even now wearing it! Even my Mum would be proud as I have hemmed it beautifully & sewn the buttons on- there was a phase in my teens where I didn’t do any finishing & I know she despaired!!

Having cut out the Pattern here, & started to sew the Skirt up here you’ll need to stop for a fortifying cup of tea. Suitably replenished the next thing to do is sew up your side seams, then try the skirt on to check fit. If it is a little loose you can choose to take it in at the Side Seams or by constructing a couple of darts in the front. To construct Perfect Darts click here, the main thing to remember is to hand tie the ends for a really professional finish. I shall be tackling this in a further post however; for the moment lets continue…

Once the Skirt fits, you can construct & attach the Waistband. First, iron on the Interfacing to the back of the Waistband, then Iron the Waistband in half. Finally on one side Iron under 1cm as illustrated.

aline 9

aline 14

Using a nice, hot Iron fold the Waistband over & Iron along the fold. It should lie completely flat. Use your tape measure to measure the 1cm turn up as you Iron. When completed it should look like the lower illustration. 

When you are happy, attach the Waistband to the Skirt. Find the Centre Front of the Skirt by folding in half, place a pin there to mark it. Fold the Waistband in half & place a pin at the half way point of the Waistband. Match the un-ironed side Right Sides Together to the Centre Front of the Skirt as illustrated. Continue pinning all around the Skirt until you have the Waistband completely pinned to the Skirt from Zip edge to Zip edge.

24   25   26

Pin at a right angle so that your sewing machine will sew straight over the pins. Leave the excess fabric at the end, do not cut it off yet!

Sew, with a 1cm Seam Allowance, from one Centre Back Zip opening the other. Remember to go backwards & forwards at the beginning & end of your seams so they don’t fall open.

Once the Waistband is attached, fold back on itself & line up the pre-ironed fold with the freshly stitched one as illustrated. On the left hand opening cut the excess Waistband fabric down to about 2cm. On the right hand opening cut the excess down to 5cm. Pin both as illustrated, & so that each centimetre Seam Allowance fold is up/back.  Stitch each closed. The Left opening stitching should run parallel with the Zip. The right approx. 3cm away from the Zip. Cut excess fabric & clip the corner.

27  28  29

Try to line up the Seam Allowance folds accurately as illustrated above left. Once trimmed place at least two pins in to hold everything securely as you stitch. Remember to go back & forth at the beginning & end of each little seam! Trim & clip as illustrated above right so that when turned out a sharp point will be formed. 

Turn the Waistband out the right way, making sure the corners are sharp, & start the pin the Waistband down along the Waist every few centimetres.

32

Match the pre-ironed fold to the stitching around the top of the Skirt & pin. Try to match this as exactly as possible- do not pin too high or too low. 

When the Waistband has been completely pinned down as best you can, sew along the edge to hold in place. Normally I would do this by hand with a regular Slip Stitch however; for this example I have done the more commercial Machine Top Stitch which; when performed neatly, provides an excellent finish.

You will need to attach the Zipper Foot to the sewing machine before proceeding, this will enable you to stitch as close to the edge of the Waistband as possible for a neater finish however; if you do not have a Zipper Foot just use the regular Foot & be aware you need to watch carefully as you stitch to get as close as possible to the edge.

33  34  35

Be aware this may take a couple of goes to get right, keep your Quick Unpick close! As illustrated in the first picture above, line the fold of the Waistband up with the Machine Stitches already sewn & pin. Then- & this is where the Zipper Foot comes in handy, because you will be able to see what you are doing- sew along this edge neatly. The finished effect should be that of the centre picture (back), & the right hand picture (front). 

Now, I do believe that is enough for one day! I need at least one more cup of tea before starting the Buttons, Buttonholes & Hem!

Remember, click the images to see enlargements.

Happy stitching!

aline skirt hack

Advertisements

5 thoughts on “Notions: Finishing your Simple Skirt

  1. Pingback: Notions: Final Touches for the Simple Skirt | Laura After Midnight

  2. Pingback: How to Make a Simple Pattern Free Skirt! | Laura After Midnigh

  3. Pingback: Notions: Beginning to Sew Up the Simple Skirt | Laura After Midnight

  4. Hey, just stumbled on these a-line blog posts, you make it look so easy to do! Can’t wait to try it out 🙂 thank you for sharing your knowledge x

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s